Hi folks,
Has anyone done any testing to see if it's possible to go down to 12/12
track width/spacing with the Staples photo paper (or PnP Blue)?
I've got a double-sided PCB here that won't route (without a stupid number
of vias) in anything above 12mils. If it's not possible to go down that far
with the Staples paper and a 600dpi laser, I'll send the boardfiles off to
Olimex. Otherwise, I'll try and make the board myself :)
While I'm at it.. has anyone got any tips for aligning the two transfers
for top copper and bottom copper?
Also, does anyone know if toner is conductive - I was planning to put a
placement guide on the top layer, but not if it'll end up shorting everything
out.
Thanks.
--
Phil. | Acorn Risc PC600 Mk3, SA202, 64MB, 6GB,
philpem@... | ViewFinder, 10BaseT Ethernet, 2-slice,
http://www.philpem.me.uk/ | 48xCD, ARCINv6c IDE, SCSI
... Clairvoyant meeting cancelled due to unforeseen events.