...and it will be pretty expensive i'll bet :-)
To Stefan:
i came to the same conclusions like you independently :-)
i'm looking for a simple method to make the experiments repeatable to get an
advantage over the exposure method if you have to do more than one board....
What i found out / think by myself until now is:
- keep out of the borders the printer uses mechanically to transport the
paper...or end up like us repairing printers... :-)
- let the silicone coating dry out...i used the heatgun to speed up
things...
- try lower ironing temperature (to let the toner melt, but not the
silicone)
- the coating has to be sticky enough but not too glossy (how about not
glossy at all?) to get the toner in the right position...
- make the coating repeatable even (i'm not sure, what kind of tool and
method to use to get a fair result pasting the silicone to the paper)
that seem to be the most important points to me.
anything not mentioned about that???
Kind regards
Martin
----- Original Message -----
From: "KD5NWA" <KD5NWA@...>
To: <Homebrew_PCBs@yahoogroups.com>
Sent: Tuesday, May 10, 2005 12:33 AM
Subject: Re: [Homebrew_PCBs] silicone paper
>I called a local office supply place, they told me they have silicone
> coated paper that can be put through a Laser Jet. I will go down tomorrow
> and see if it looks any good, it's supposed to be glossy finish.
>
> If it looks ok I'll buy some and try it and see if the transfer looks any
> good. I have the feeling though that it's a different kind of silicone,
> the
> description said it's for use with Ink Jet printers and making high
> quality
> color presentations.
>
> At 03:40 PM 5/9/2005, you wrote:
>>On Mon, 9 May 2005 21:21:33 +0200, Martin Haverland
>><professional@...> wrote:
>>
>> >
>> > Let's keep us beeing informed about our further silicone experiments, i
>> > will
>> > do some by myself now!
>> > Kind regards
>> > Martin
>>
>>
>>I fixed the printer too, a paper fragment was attached to a roller it
>>shouldn't be attached to.
>>But still the silicone is frustrating.
>>I tried about 10 prints before i noticed the file is faulty, not the
>>silicone paper, missing chunks of lines cause they were too thin.
>>The silicone paper tends to stick to places where it shouldn't. It is good
>>to leave about an inch on the leading edge uncoated and also use only full
>>A4 sheets not half sheets.
>>
>>ST
>>
>>
>>
>>Be sure to visit the group home and check for new Bookmarks and files:
>>http://groups.yahoo.com/group/Homebrew_PCBs
>>Yahoo! Groups Links
>>
>>
>>
>>
>
> Cecil Bayona
> KD5NWA
> www.qrpradio.com
>
> 'Never argue with an idiot. They drag you down to their level then beat
> you
> with experience.'
>
>
>
>
>
> Be sure to visit the group home and check for new Bookmarks and files:
> http://groups.yahoo.com/group/Homebrew_PCBs
> Yahoo! Groups Links
>
>
>
>
>
>