javaguy11111 wrote:
> My results were not as good as Stefan's. First the coating did not
> come out as smooth as I would like to have seen it.
Likely due to the texture of the paper acting to self-level
the silicone film. The paper is also much more compressible
than the transparency film which compensates for irregularities
in both the knife and surface upon which the film/paper rests.
I have heard of success using printer label backer sheet for
this same purpose. Is there some reason this is not a
viable solution? It would seem quite cost effective.
--
uhmgawa@... www.gnu.org