--- In
Homebrew_PCBs@yahoogroups.com, "Thomas" <teecee@c...> wrote:
> would I be correct in saying that Toner generaly melts at around 200 C /392 F ?
>
> Thanks
> Thomas
>
> [Non-text portions of this message have been removed]
According to the manual for the HP4L, the fuser is 180C.
But the specs on the media call out 200C for 0.1 seconds.
This is a relatively short time relative to the 2-3 minutes
recommended for the iron method.
And the thermal mass is approximately zero compared to the board.
Would be interesting to have some experimental data with actual
numbers.
mike