I am milling boards. My artwork is in DXF format. It sounds like you
are doing something else. The Think & Tinker 60 degree can mill and
produce starter divots.
--- In Homebrew_PCBs@yahoogroups.com, Dave VanHorn <dvanhorn@d...> wrote:
> At 12:27 PM 11/18/2004, crankorgan wrote:
>
>
>
> >With the snap grid on I click twice in the center of the pad. It is
> >recorded as a location. During milling you get a starting diviot. The
> >diviot is tiny. Smaller than your drill bits.
>
> Ok, I was going to define this as a pad, with a small center hole,
but I
> don't know what size to use, so that it dosen't dissapear.
>
> Then I would just not have the board drilled at all.