Jeremy, would you suggest
http://www.caswellplating.com/kits/copper.htm or this
http://www.caswellplating.com/kits/flashcopper.html Mike
--- In
Homebrew_PCBs@yahoogroups.com, "Jeremy Taylor" <jeremy@e...>
wrote:
> While I'll admit Markus's plating system is a piece of working art,
to do plated holes you do not have to be so talented in design and
fabrication. A simple 2-5 Gallon plastic bucket, two copper anodes, A
power supply, (could be as simple as a car battery charger) and some
way to regulate the power( could be a simple as a lamp dimmer) You
could use two anodes, or just one (but you'd have to flip the board)
> In my tank, the anodes (4X6) are not as big as the pcb(6X9), and
this does not matter as much as copper is plated out of the solution,
more than it is directly from the anodes - I also have a larger
distance between the pcb and anodes.
>
> The kit from Caswell includes 2 buckets, heater, anodes, cleaning
and plating chems. It works very well with the ink, and less than
$200 for a complete but- minimal system.
>
> JT
> http://www.soundclick.com/jtsound
> ----- Original Message -----
> From: Dave Mucha
> To: Homebrew_PCBs@yahoogroups.com
> Sent: Thursday, July 29, 2004 11:53 AM
> Subject: [Homebrew_PCBs] Re: Plating thruholes.
>
>
> --- In Homebrew_PCBs@yahoogroups.com, "mikezcnc" <eemikez@c...>
wrote:
> > I can't believe- Markus is a member of this board! It is a very
> > professionally looking setup that you created.
>
>
> That is what I was trying to say to Ballendo. the 'brain trust'
on
> this board peaks in the 'making PCB's area and is THE place to
get
> ansers when you want to make PCB's.
>
> And yes, Markus holds the bar very high for the rest of us !
> I just wish he were close by my area.
>
> There is a NJ robotics society and one of the guys and a laser
board
> etcher. about 4 ft cube. Wanna talk about envy ? Problem for
me is
> that he is too far away....
>
> Oh, may I respectfully request that you keep your questions on
the
> open list and not in personal e-mails? the rest of us would like
to
> listen in.
>
>
> Dave
>
>
>
>
>
>
> Be sure to visit the group home and check for new Bookmarks and
files:
> http://groups.yahoo.com/group/Homebrew_PCBs
>
>
> Yahoo! Groups Sponsor
> ADVERTISEMENT
>
>
>
>
>
> --------------------------------------------------------------------
----------
> Yahoo! Groups Links
>
> a.. To visit your group on the web, go to:
> http://groups.yahoo.com/group/Homebrew_PCBs/
>
> b.. To unsubscribe from this group, send an email to:
> Homebrew_PCBs-unsubscribe@yahoogroups.com
>
> c.. Your use of Yahoo! Groups is subject to the Yahoo! Terms of
Service.
>
>
>
> [Non-text portions of this message have been removed]