Archive of the former Yahoo!Groups mailing list: Homebrew PCBs

Hey Gang,
Many years ago I made some double sided boards for a guy
at work building a power amp. I took the PC layout from the magazine
he had. I taped it to a board. I used a sharp point to mark each
component hole. I then drilled the hole locations. I cleaned the
board with steel wool and dried it. I wore white cotton gloves during
the next step. I took a marking pen. I put a dot of ink at each hole
on both sides of the board. I then turned the dots into pads. Then
it was connect the dot time. I then etched the board. Success!

John