I have a piezo allready converted to flatbed, but dont have the ink
carterges, have them ordered, may call back and see if the co i
ordered from would sell emty carterges, you are right steve-the
bubble jet is out as far as i am concerned.will post when and if
progress is made.
mebo
--- In
Homebrew_PCBs@yahoogroups.com, Stefan Trethan
<stefan_trethan@g...> wrote:
> On Fri, 5 Mar 2004 13:28:09 -0800 (PST), pebo festus <mebo31@y...>
> wrote:
>
> > hey---this looks promising,i bought some MOP&GLOW,
> > which has some teflon in it. info on the container
> > states that it can be cleaned off the board(or floor)
> > with lysol and ammonia, 1 cup each to 1/2 gallon of
> > water.
> > I put a small dot on a pcb and it spread a small
> > amount but it dryed hard, tryed to remove it by
> > scraping with a screw driver, it came off but not
> > easy, i had not cleaned the board and it adhered to
> > it.looks like its time to emty an ink carterdge and
> > refill with mimwax. may have to add a small amt of red
> > food dye containing alcohol to the mimwax.
> > mebo
>
>
> DO IT, GO!
>
> i look forward to the results for a while now.
> I still have my doubts but maybe in the end it works.
> the resist pattern printers i see on the web look certainly
> like inkjets.....
>
> i think it is only a question of the printing head.
> i have wasted my time with a bubblejet, maybe if i had
> bought a piezo for it i would now already print my boards this
> way.
>
> ST