On Tue, 24 Feb 2004 19:40:53 -0000, joshdewinter <
joshdewinter@...>
wrote:
>> I casted new gears and installed a new thermal cut-off device and
>> I had a functioning laminator.
>
> Do you know by any chance what the cuttoff temperature is of your
> laminator now? I've got a cheap laminator, but it just doesn't work
> that well. I think it's because it just plain doesn't get hot
> enough. When I modified it to get hotter though, the heating
> element fried. I'm using a fuser now and getting pretty good
> results. The laminator would be nice though, as I wouldn't have to
> manually feed it like the fuser.
>
> You mentioned casting new gears too. What process did you use for
> this? That sounds pretty impressive.
>
> Thanks
> Josh
you can motorize the fuser you know, just like it was in the printer.
I too am very interested in the casting, i would appreciate webpages
and conversation. this is maybe not the place, there are already some
other groups.
I have read a little already in the past, but i do not know where to get
the materials
(in the eu).
Josh, if you have a look at the existing groups and check them out, please
tell me which you think is suitable and join. i am interestid in "plastic
casting" mainly.
but i am too fascinated by aluminium casting, but this is more effort so
the plastic thing
would be fine for now (and i think better detail parts are easier
obtainable).
I will check them myself in a few days time maybe but if you do it before
i can save the time.
regards
Stefan