On Tue, 24 Feb 2004 09:28:08 -0000, gmanca101 <
gmanca101@...> wrote:
> I found this pcb workshop site,
> http://www.cia.com.au/rcsradio/makepcb9.txt, from Australia. All
> though they describe im somewhat detail their roll tinning machine it
> appears that the bottom roller is rubber? Is that possible? I know a
> major deterant for me is the fact that the metal roller needed flux.
> If the top rubber roller was not affected by solder, then why isnt it
> possible to have the bottom one as well?
>
because of no roller is affected by solder no pcb will be affected too.
and then it will just come out hot.
(one roller carries the solder to the pcb)
ST