Archive of the former Yahoo!Groups mailing list: Homebrew PCBs
Subject: Re: etching VS casting (Long post)
From: "gmanca101" <gmanca101@...>
Date: 2004-02-18
It good that this was brought up because I am doing some casting of
my own. Right now, I have been using the Alumlite RTV MoldMaking Set
to create master mold of the gears found in my GBC 95P laminator. I
also use Casting Craft Liquid resin for the duplicate part. I would
recomend using the plastic method if you are going to make a
duplicate item. Keep in mind that any imperfect features from your
original will come out in a mold.