On 11/24/2016 9:24 PM,
alan00463@... [Homebrew_PCBs] wrote:
>>I bough one from Jamesco and it works well, I don't have to sit there
>>and put the board through multiple times, while it does it's thing I get
>>the etching chemicals ready, also make sure you set the right
>>temperature for the heater.
>
>>--
>>Cecil - k5nwa
>
> Which one [laminator] did you buy, Cecil ?
>
>
> ------------------------------------------------------------------------
> Posted by: alan00463@...
Apache AL13P, I have two of them, on one is in the box has not been
opened and is a backup. For a while they were really cheap so I bought a
spare. The kit is worth it, not only for the PCB features but also for
the safety features, there is no over temperature sensor or circuit to
shut off the laminator but the board monitors the temperature and shuts
the heaters off to prevent fires from over temperature, and has a cool
down mode to allow the rollers to cool down so they don't deform.
The ALP13P is very heavy duty but has one major failing, it doesn't have
an over temperature sensor to prevent fires
--
Cecil - k5nwa
http://thepartsplace.k5nwa.com/