| previous by date | index | next by date |
| topic list | next in topic |
Hi all,
I'm normally just lurking but I thought I would share this tip. I had run out Orange Dry Peel Negative Film, the solution I found was to use Photosensitive Dry Film on some laser drafting film the only problem I had was to find the correct temperature on my laminator which terned out to be a lot lower than I use for copper clad board. there's is no need to stock "Orange Dry Peel Negativ film" and its cheep.
This all came about as a friend asked me to eatch some some brass name plate for his 2" traction engine as he new I make my own PCB,s. Not a problem I thought, well I used Photosensitive Dry Film on the brass sheet, as the brass was rather thick I had to tern up the temperature on my laminator to get good adhesion.