I suppose that the grit of the sandpaper makes a difference. Maybe
something like 400 or so? And would wet be better?
-DM
----- Original Message -----
From: "Leon Heller" <leon_heller@...>
To: <Homebrew_PCBs@yahoogroups.com>
Sent: Sunday, December 21, 2003 4:06 PM
Subject: Re: [Homebrew_PCBs] Re: How to cut circuit boards?
>
> ----- Original Message -----
> From: "grantfair2001" <grant.fair@...>
> To: <Homebrew_PCBs@yahoogroups.com>
> Sent: Sunday, December 21, 2003 7:52 PM
> Subject: [Homebrew_PCBs] Re: How to cut circuit boards?
>
>
> > I just cut fine or very fine sandpaper with the snips, as if they were
> > scissors. I only make a few cuts each sharpening.
> >
> > I read long ago that this was a good way to sharpen scissors, and it
> > works for that too. Why it works, I don't know. But it does the trick.
>
> My mother used to sharpen scissors that way, 50 years ago. I've always
been
> doubtful about it.
>
> Leon
> --
> Leon Heller, G1HSM
> Email: aqzf13@...
> My low-cost Philips LPC210x ARM development system:
> http://www.geocities.com/leon_heller/lpc2104.html
>
> Be sure to visit the group home and check for new Bookmarks and files:
> http://groups.yahoo.com/group/Homebrew_PCBs
>
> To unsubscribe from this group, send an email to:
> Homebrew_PCBs-unsubscribe@yahoogroups.com
>
>
>
>
> Yahoo! Groups Links
>
> To visit your group on the web, go to:
> http://groups.yahoo.com/group/Homebrew_PCBs/
>
> To unsubscribe from this group, send an email to:
> Homebrew_PCBs-unsubscribe@yahoogroups.com
>
> Your use of Yahoo! Groups is subject to:
> http://docs.yahoo.com/info/terms/
>
>