Archive of the former Yahoo!Groups mailing list: Homebrew PCBs
Subject: How to cut circuit boards?
From: "javaguy11111" <javaguy11111@...>
Date: 2003-12-20
Any suggestions on cutting circuit boards. I have used a bandsaw, but
it tends to be slow, dusty and inaccurate. I have tried paper shears,
but the board tends to get warped and is only good for about two
inches and it is too hard to cut any further.
I have seen a few references to using a diamond tile saw. They have
wet tile saws with a diamond blade at home depot for $88 but it seems
that the blade would get gummed up with epoxy and not cut.