Archive of the former Yahoo!Groups mailing list: Homebrew PCBs

Mark,
I have resolved one issue... Cleaning with Acetone didn't do good enough of a job. After re-cleaning the carrier with mild detergent and scotchbrite, Drying with fresh clean cotton dish towel, I am not getting the paper jam indication upon the first pull, and am not getting residual toner on the sheet. Poor conductivity at first, I think. However now, when I print from the PC, the carrier pulls in to about.75 past the trigger hole, and stops with a jam. Is this likely due to the high resistance of the pullup resistor (30.1k) preventing the trigger from working?
Thanks,
Roger

 

Roger,

This usually happens if the NPIS doesn't see the hole in the carrier. Did you remember to drill one?

Mark

-----Original Message-----
From: "Roger Blair Roger.Blair@... [Homebrew_PCBs]"
Sent: Apr 5, 2015 10:33 AM
To: Homebrew_PCBs@yahoogroups.com
Subject: Re: [Homebrew_PCBs] Re: DLP MCU version troubleshooting, help needed



Hi Mark (& Marc), again...
I found a few overlooked corresponding emails from earlier in time, and with a little more information... I have just completed wiring the printer as follows, and have a fault:

E260dn DLP Hookup
Device	Function	Conn	Color	ATtiny13 MCU	Function
Operator Panel	3.3V	J5-5	BL	2	Pad no.’s = Pin no.’s	PB3
Cover Open Switch Wires	5V	J7-1	YE	8	VCC
5V	J7-2	RD
GND	J7-3	BK	4	GND
Thermistor Substitute	5V	J12-1	BK	(J12-1>2.7k>J12-2) (RD-VI-RD)	Fuser Temp
GND	J12-2	BK
New Paper In Sensor (was narrow sensor)	0-5V	J14-1	RD	(Splice J14-1 wire to Sensor)
5V	J14-2	WT	7	Pad no.’s = Pin no.’s	SCK
GND	J14-3	BK	4	GND
	Sensor	RD	(Splice Sensor wire to J14-1)
	Sensor	BL	5	(4.99k to PAD 8 VCC)