At 10:12 AM 4/11/02 -0700, Steve Greenfield wrote:
>How 'bout this little thing? Too much weight to put in a plotter,
>but maybe in a homebuilt router/engraver.
>
>http://www.harborfreight.com/cpi/ctaf/Displayitem.taf?itemnumber=43155
>
>58,000rpm no load. There is a Harbor Freight Tools about 1/2 mile
>from my house.
That is probably the same as the unit I mentioned from Princess Auto. I
think that its cheaper here in Canada, though ($30.00 Canadian vs $36.00 US).
>How are you guys measuring runout? Drill with a stiff bit then
>measure the size of the hole? I don't have a micrometer that can
>measure the inside of a round hole.
I've done it that way (although that method includes any error resulting
from an off-balance drill bit). I also just stick a solid carbide shaft
into the chuck and measure both play and run-out when rotating the shaft by
hand.
dwayne
Dwayne Reid <
dwayner@...>
Trinity Electronics Systems Ltd Edmonton, AB, CANADA
(780) 489-3199 voice (780) 487-6397 fax
Celebrating 18 years of Engineering Innovation (1984 - 2002)
.-. .-. .-. .-. .-. .-. .-. .-. .-. .-
`-' `-' `-' `-' `-' `-' `-' `-' `-'
Do NOT send unsolicited commercial email to this email address.
This message neither grants consent to receive unsolicited
commercial email nor is intended to solicit commercial email.