--- Adam Seychell <
adam_seychell@...> wrote:
> I'm thinking even if etchant doesn't get inside the
> motor housing
> then fumes might, and so could possible corrode the
> steel.
Adam,
For whatever reason I did not read this part of your
post. I think you are guaranteed a fine micro mist of
etchant (Just like in a hot shower) inside the etching
machine. The only answer that I see as viable (But not
practical...) is to totally disassemble the motor and
apply protectant to every part that is suspect. If
possible, I would attempt to figure out how to mount
the motor outside and away from the etchant.
Best regards
Marvin Dickens
Alpharetta, Georgia USA
=====
Registered Linux User No. 80253
If you use linux, get counted at:
http://www.linuxcounter.org__________________________________
Do you Yahoo!?
Free Pop-Up Blocker - Get it now
http://companion.yahoo.com/