Rick, can you share the source, part number and mfgr, or any other details about the "special waxed paper"?
--- In Homebrew_PCBs@yahoogroups.com, "Rick Sparber" <rgsparber@...> wrote:
>
> The special waxed paper came in WAY ahead of the promise date - got it today. Wonderful material! I drafted a 1" long scale with 10 major and 30 minor divisions on it using DesignCAD V14. It was then printed, mirror image, onto the wax paper. I printed 4 coupons at a time. Two of these coupons were taped to 2 small pieces of copper plate.
>
>
>
> I ran my copper plates with the waxed paper on top through my laminator 10 times. Then I put the samples in the freezer for 15, not 30 minutes. The paper fell away from the toner. Then I dropped the two samples in rather used up ferric chloride that I put out in the Arizona sun. Every 15 minutes I would bump the container. After an hour I pulled out the samples. The toner was solid and I had etched down about 0.001" according to my caliper. The fine lines of the scale and numbers all looked perfect.
>
>
>
> My last small challenge is figuring out how to color the background and leave the raised copper areas shiny. I tried coating the entire surface and then abrading the raised area. Didn't do a very good job but the technique shows promise.
>
>
>