> Jeff Heiss wrote:
>
> I am drilling holes with #96 (0.006 inch) drill
> bits. However, not one hole has been drilled
> <SNIP>
> Has anyone successfully drilled holes this small
> before? Are there any suggestions for a drill
> or rotary tool that has low runout?
In real measurements that is 0.15mm.
I regularly do 0.2mm in my Sakai/Mannix drill
press. Broken bits only ever happen from my
own clumsy hands.
I suspect it would do 0.15mm
The drill press might seem expensive to start
with but at many $ a pop for broken drills it
would pay for itself quick enough.