--- Ted Huntington <
thunting@...> wrote:
> I bought some of this but have not tried it yet.
> Does it work?
It works. You can expect a layer of tin around 0.0003
to 0.0004 of an inch in thickness depending on the
temperature of the tinning bath, how long the pcb is
in the tinning bath and how clean the board (And
tinning environment is...).
Always clean and degrease the board prior to tinning.
Make sure the tinning environment is clean (Whatever
you have the solution in...) and the temperature of
the tinning bath is reasonable.
Best regards
Marvin Dickens
Alpharetta, Georgia USA
=====
Registered Linux User No. 80253
If you use linux, get counted at:
http://www.linuxcounter.org__________________________________
Do you Yahoo!?
Protect your identity with Yahoo! Mail AddressGuard
http://antispam.yahoo.com/whatsnewfree