Thanks Pulsar Pro's appears to be Acrylic. Hard ware store sold me glue of industry and said if seam was tight I should not have a problem. It will not be storage. Petcock for drain into proper container. Kevin
________________________________
From: lists <
Stuartlists@...>
To:
Homebrew_PCBs@yahoogroups.com Sent: Friday, August 24, 2012 2:57 AM
Subject: Re: [Homebrew_PCBs] Re: Spray Etcher
In article <
k13l1h+40pi@...>,
cunningfellow <
andrewm1973@...> wrote:
> I would advise against it.
> Acrylic is not suitable material with CuCl.
> (PE,PP, PVC are all OK)
That's interesting because an awful lot of designs seem to use acrylic but
I was advised against it by a supplier when I was looking to build a new
tank (Still haven't built it)
--
Stuart Winsor
Only plain text for emails
http://www.asciiribbon.org [Non-text portions of this message have been removed]