It's not a question of just adjusting the scaling; the problem is that it's inconsistent. Sometimes it would come out too small, sometimes it would come out too big...
However I have now managed to print at least three perfect copies using the HP photo paper by printing my layout at the bottom of the page. This seems to confirm that the speed of the paper is only inconsistent at the top of the page. I think that is because the roller that pulls the paper out of the tray is also responsible for pushing it over the drum, and some slippage occurs with the thicker and glossier paper. Once the paper hits the fuser though, then there is enough pressure to pull the paper with a constant speed.
Anyways, my board has been printed and etched, and it looks perfect. In the future, I think I will probably cut strips of TTS or photo paper and tape it to another sheet to make sure I always print on the bottom of the page without wasting a whole sheet.
In general, I think the straighter the paper path, the better. With the old HP LJ 4 at the office I used to use the manual feed and open up the back, so that the paper would not curve up back to the front, but that is not possible on this ultra-small Samsung.
For now, the little Samsung at $90 works fine as long as I can work around its limitations.
Thanks,
Pete
--- In Homebrew_PCBs@yahoogroups.com, DJ Delorie <dj@...> wrote:
>
>
> When I did TT, my process was to print a "calibration board" and go
> through all the steps until just before etching, and measure the pcb
> itself to find out what the X and Y scale factors are. Each step along
> the way might alter the dimensions somewhat, so it's important to just
> check the results you care about.
>
> gEDA/PCB, btw, has separate X and Y calibration values you can fill in
> to adjust printouts, just for toner transfer.
>