Archive of the former Yahoo!Groups mailing list: Homebrew PCBs

I agree,

It is easy to cut some copper tracks but it is very difficult to remove the
unwanted copper on good quality FR4.

Bertho



From: javaguy11111 Sent: Thursday, June 14, 2012 12:56



I have done a little experimentation in the past manually cutting traces
using graver techniques. The copper itself cuts just fine, but getting it
separated cleanly from the fiberglass is more of a problem.

I would think Cricut would have a similar problem issue. Still if it works,
that would be great.



[Non-text portions of this message have been removed]