I do believe you are speaking of their old model!!!
they have a new ver.
working from memory it takes about 3 min to get up to temp.
and I would say about 1 minute or less for a full sheet is about right.
from what I gathered from Frank he has to modify very little and if my
memory
doesn't fail me here I think it has something to do with the
volume/thickness of the board but I could be wrong. :-)
regards
victor
----- Original Message -----
From: "Steve" <alienrelics@...>
To: <Homebrew_PCBs@yahoogroups.com>
Sent: Tuesday, October 28, 2003 12:38 AM
Subject: [Homebrew_PCBs] Re: Laser toner transfer - IT WORKS
> --- In Homebrew_PCBs@yahoogroups.com, "Victor Faria" <victorf57@c...>
> wrote:
> ...
> > OH, Frank at dynaart said that you should only have to run you board
> through
> > the laminator once but I do run it through twice I'M a chicken.
> ...
>
> That's because the DynaArt laminator has been modified to roll it
> through very, very slowly. Unmodified laminators take less than a
> minute for a full page feed.
>
> Steve Greenfield
>
>
>
> Be sure to visit the group home and check for new Bookmarks and files:
> http://groups.yahoo.com/group/Homebrew_PCBs
>
> To unsubscribe from this group, send an email to:
> Homebrew_PCBs-unsubscribe@yahoogroups.com
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>