I did try using toner transfer technique (laminator + magazine) but my drill stand is not really fixed. I am thinking on getting the Proxxon later. In Malaysia, all the tools are probably a lot more expensive than the one in the States (I used to live and studied in St Louis for almost 10 years back in 1995 - 2001).
Anyway, I just came back from a hardware store getting a airbrush compressor and just ordered Pebeo Vitrea 160 from Kuala Lumpur. Also, I just purchased an oven. These few days will be focused on getting the solder mask and silkscreen using the technique described by Retromaster.
--- In Homebrew_PCBs@yahoogroups.com, "Harvey McRae" <hlmcrae@...> wrote:
>
> I have made a little tin template for my little PCB's I bend the one edge and one end to act as a guide, place the pcb into the corner .... go to my little dremel drill stand, and within a minute or two (I'd say a minute) I have all 20 + holes drilled. My tin template was the top of the vegetable can that we had for lunch.. Remember my board is only 1x 1.5 inches.. I drilled ten night before last, with all the change of pieces in less than 15 minutes.
>
>
> Harvey L. McRae
> 838 McKenzie Rd.,
> Kelowna, B.C. V1X2B3
>
> Web: www.harriscreekcentral.webs.com
> ----- Original Message -----
> From: sailingto
> To: Homebrew_PCBs@yahoogroups.com
> Sent: Tuesday, May 11, 2010 9:26 AM
> Subject: [Homebrew_PCBs] Re: Printing on a solder mask
>
>
>
> > sense. How will you know where to drill the holes without a CNC? Or do you
> > plan to get one? Perhaps I am missing something.
>
> Well, not sure if drilling first will work or not, my idea was to print drill pattern on thin paper so holes 'n vias could be seen from back side, put TT paper on one side of PCB, run thru laminator once to stick paper in place. That would cause the drill pattern of all holes to be visible, then drill thru this thin paper.
>
> With all the holes drilled, I was hoping lining up both sides of TT paper to the existing drilled holes would improve hole registration. Currently my double sided boards have most of the traces on one side, with only a few on the other side. This keeps the holes to a minimum.
>
> As I write this, I'm not sure it will work - maybe I'll get to try later this week.
>
> Ken H>
>
>
>
>
>
> [Non-text portions of this message have been removed]
>