Hi there- new subscriber here just saying hi. I've been experimenting
with Cricut machines for the last several months.
Not long ago I started trying to make PCBs and have posted a few blog
articles about my results with the "scratch & etch" and "PCB plotting"
methods. I didn't really realize what others had done with these
techniques until after I tried them, so I'm still learning.
Although I've used only 0.01 (super thin) pcb material so far, I'm
pretty sure a thicker board will fit OK albeit quite tightly provided
you pay attention to the roller wheel positions.
all the PCB-related posts are in the "Eagle" category on my blog:
http://everhack.blog.atxhackerspace.org/category/eagle/enjoy,
David