I did manage to get a degree of adhesion on a test board by using a clothes iron set to the highest setting. But it was pretty patchy. I had scrubbed the board first with a nylon scourer and also wiped over with acetone to de-grease it.
Regards,
David Partridge
-----Original Message-----
From:
Homebrew_PCBs@yahoogroups.com [mailto:
Homebrew_PCBs@yahoogroups.com] On Behalf Of jmelson2
Sent: 23 March 2011 16:05
To:
Homebrew_PCBs@yahoogroups.comSubject: [Homebrew_PCBs] Re: Toner transfer failure
There might be a plastic or oily film on the board. I use dry film resist, but have to scrub the board with abrasive cleanser and/or very fine sandpaper to get good adhesion.
Jon