thanks...
in fact in the past i did a lot of rework with different "sharpie" like
pens.
(when i used photoresist and had problems with getting the films/exposure
right).
most inks in these pens works also with hcl h2o2 if used in the pen they
are sold for.
these nylon tipped pens sometimes are made like the outline of a star.
the ink is carried through capillary effect and gravity.
(the star shape offers a lot of thin channels, thus a lot capillary effect
is created)
altso the overall tip is rounded off, as i have seen.
if you drag it along the surface the trailing edge is lifted off the
surface.
this allows a lot of ink to stick to the surface.
the plotter pens are in principle only a round tube.
in the center is a thin wire which is spring loaded.
(i assume this wire is for aiding in capillary effect and making contact to
the surface).
the spring loading down the center wire (rounded tip on this wire) is very
light pressure, thus
it is depressed fully into the tip cylinder when contacting the paper (pcb)
.
when dragging the metal tip plotter pen the trailing edge is flat against
the surface.
the ink is only within the tube so the resulting layer of ink is very thin.
there are x grooved tips. this means 4 grooves are cut in the pipe tip to
make a better
flow of ink. with my carbide pens only the 0.18mm diameter is x grooved and
i can't see
any difference in ink layer thickness.
i guess this is most of what i know about this stuff.
i wanted to use metal tip pens because they produce a constant line with,
regardless of pen speed.
maybe i take some photos of the result i get with nylon tip pen (the
teardrops).
so the main problems i would say are:
a) the copper doesn't "suck up" the ink like paper (it is more like a ohp
transparency).
b) the expensive carbon tip pens are constructed so that the layer is to
thin.
c) the nylon tips result in teardrops because linewith is a function of pen
speed.
st
On Sat, 27 Sep 2003 15:37:29 -0000, Ben H. Lanmon <
bhleavi@...>
wrote:
> GC Electronics is under GC/Waldom website does not tell you much as I
> believe that you have to be registered dealer to get to most information
> on the site. They do give you access to there Dist. locator but think
> they are only U.S. and Canada that I saw.
>
> Mouser www.mouser.com I believe carries the GC Electronics resist pens
> but don't list them as GC Electronics. They list two pen widths
> 1/32" and 1/64" or .79 mm and .39 mm. these list for $2.48 and $2.64
> each Page 1040 in Cat.#615
>
> MG Chemicals has a resist pen www.mgchemicals.com I buy MG Chemicals
> thru Circuit Specialists www.web-tronics.com MG Chemicals pen is only
> listed for use with Ferric Chloride and Sodium Persulfate, not for use
> with Ammonium Persulfate.
>
> These pens look just like a Shapie, in fact I use a fine point Shapie to
> do touch up when needed on my boards, I use Ferric Chloride Etchant.
>
> Ben
>
>
>
> Be sure to visit the group home and check for new Bookmarks and files:
> http://groups.yahoo.com/group/Homebrew_PCBs
>
> To unsubscribe from this group, send an email to:
> Homebrew_PCBs-unsubscribe@yahoogroups.com
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>