exactly for the egg :-)
for the walls... I have designed a mill see here :
http://www.usinages.com/ma-fraiseuse-v2-a-vos-critiques-svp-t8144-195.htmlso it's quite easy to produce the replacement walls from epoxy (pcb
copper boards)
An even faster solution that I have not yet tested would be to use a
laser cutter see here :
http://www.usinages.com/soft-pour-plp-c50-t22761.htmland you will recognize that I am very close to be able to "lase" the GBC
walls !!!
JP
Le 19/10/2010 22:13, Jean-Marc Spaggiari a écrit :
>
> > If you don't increase the temp you won't get good results as the temp
> > will not be high enough to melt the toner... whatever the motor
> speed is...
>
> I see. It's like if I try to cook an egg but putting it on 20C water.
> I can let it there as long as I want, is will never harden...
>
> > If your "walls" are the same as mines I could probably mill the walls
> > for you... I already did it 3 times ;-)
>
> Thanks A LOT for the offering. I will receive the laminator in about a
> week. So I will let you know at that time. But I'm curious, how are
> you going those "walls"?
>
> JM
>
>
[Non-text portions of this message have been removed]