Looks good, thanks, nice to know the formula works.
One thing I found with electroless tin was that when used on PCB tracks on a high impedance circuit, was the tin seemed to coat the non-copper areas of the FR4 board and significantly reduce the impedance.
Malcolm
I don't suffer from insanity I enjoy it!
--- On Thu, 8/19/10, fredbutz <fredbutz@...> wrote:
From: fredbutz <fredbutz@...>
Subject: [Homebrew_PCBs] Re: Now, tinning
To: Homebrew_PCBs@yahoogroups.com
Date: Thursday, August 19, 2010, 11:36 PM
You can find the video on this page.
http://www.voodooengineering.com/index.php/component/content/article/46-tinning/89-diy-tin-plating-solutiion
--- In Homebrew_PCBs@yahoogroups.com, "fredbutz" <fredbutz@...> wrote:
>
> Well I tried it.
> Worked great for me. I made a video and will post it tomorrow afternoon.
> me
>
> --- In Homebrew_PCBs@yahoogroups.com, "fredbutz" <fredbutz@> wrote:
> >
> > I'm about to try the Sulfamic acid one. I also got the chemicals on EBay. I'll let you know.
> >
> >
> > --- In Homebrew_PCBs@yahoogroups.com, Larry Battraw <lbattraw@> wrote:
> > >
> > > > > > I have very good luck with elctroless tin. The formula I use came from the September 1971 issue of Ham Radio magazine.
> > > > > >
> > > > > > .5g Stannous Chloride
> > > > > > 2.0g Thiourea
> > > > > > 3.0g Sulfamic Acid
> > > > > > 100.0 mL Distilled water
> > > > > >
> > > > > > The solution is ued cold, I never tired heating it. It plates up in a few minutes and does a goog job but can't be use as a resist for further etching. The solution does not keep and I always make up a fresh batch for each board making session. I would usually mix up less than 100 mL depending on the size and number of boards I was doing.
> > > > > >
> > > > > > Craig
> > >
> > > Has anyone else tried this? I ordered the chemicals off eBay and
> > > tried it with sulfamic and sulfuric acid (separate times) and it does
> > > not seem to work. I was very careful measuring, used distilled water,
> > > and cleaned the copper with sandpaper so it was completely exposed.
> > > The recipe using sulfuric came from here:
> > > http://www.finishing.com/0200-0399/260.shtml
> > >
> > > The only thing I can think of is that the Stannous Chloride I have is
> > > not actually what it seems to be since it's the only thing I haven't
> > > been able to substitute something else for. I tried a recipe for
> > > electroplating which uses Stannous Chloride and Hydrochloric Acid and
> > > also had no luck-- it turned the copper I was trying to plate black.
> > > Perhaps I have Stannic Chloride? I have no idea how they differ.
> > >
> > > Thanks-
> > > Larry Battraw
> > >
> >
>
[Non-text portions of this message have been removed]