-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1
On 21.Jun.10 21:12, Slavko Kocjancic wrote:
> Hello...
>
> I'm make PCB with toner transfer quite long. It work's so well...
> And I can make PCB for small QFP with 0.8 or 0.5mm grid without problems.
> I didn't know that my printer has bad output at all.
> But when I go to drill my board with CNC (was drilled by hand) then I
> notice that problem as all holes isn't drilled in centre.
> I blame CNC (homemade) 1'st for inacurracy but came out that CNC is
> accurate but not the printer.
>
> Then I just put commercialy made film to my printout and see difference
> easy and goes to investigate. BAD bad Bad printer. And not just one. !
>
> Slavko.
>
>
Heh :)
One of reasons that I've never even considered going TT route (printer
inconsistencies).
Commercially made films, photo precoated boards, HaOH/Silicate
developper, HCl + H2O2 etchant and I have my prototypes in less than an
hour.
Oh, yes, CNC is IEHK IEP1325 Chinezzee router (1250x2440 mm working area :))
- --
Best regards,
Zoran A. Scepanovic
zastos@...
www.zastos.com
www.zastos.biz
+381 63 609-993
=====
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.9 (MingW32)
iEYEARECAAYFAkwg50AACgkQeEZQoPqyQm3RBwCfchlJMdKDjdd3sZRb0NO0hFnD
dZIAoJbEEFqKMfFGe5H4cXOHa0JX3tMZ
=qYps
-----END PGP SIGNATURE-----
[Non-text portions of this message have been removed]