--- In
Homebrew_PCBs@yahoogroups.com, kabowers@... wrote:
>
> On Mon, 21 Jun 2010 19:00:45 +0200, you wrote:
>
> I apologize if this is a dumb question, but do you
> have every stage of the print stream set to 100%. In the
> past I have goofed and had "fit to page" enabled in either
> the board software or Windows printer driver configuration
> and gotten similar results. This can easily be hidden if one dimension
> of the board is close to one of the paper dimensions.
>
> May also be dirty/glazed drive rollers in the printer.
>
> Keith Bowers WB4LSJ- Thomasville, NC
>
There are no stupid questions :-).
But yes, in eagle CAD (the program I use for PCB design) everything is setup at 1 to 1 output. Checked and checked again in the printer driver.