I'll butt in and mention that you can get several varieties of carbine
scribes at (of all places)
Amazon.Com. Some are very inexpensive, a few bucks, some are a bit
pricier. The one I purchased from Edmund Scientific about ten years ago
cost about 2 bucks. At that time, I was doing very small quantities of
G-10 epoxy glass almost exclusively. The thing still works.
Roland F. Harriston, The Pedantic Douche (PD)
Alessio Sangalli wrote:
>
> On 04/14/2010 12:26 AM, Eddie Stassen wrote:
>
> > I use a carbide tipped laminate scoring cutter, which works ∗really∗
> > well. Its far sturdier than a glass cutter. I suspect the glass cutter
> > will be ok, but those little wheels have a tendency to come off after a
> > while.
>
> Ok, but where did you get yours? How much does it cost? Do you have a
> picture or a link?
>
> bye
> as
>
>