OK, I think I understand - the iron does the actual toner transfer, then the laminator rolls with pressure to make the toner stick - is that the idea?
ken H.
--- In Homebrew_PCBs@yahoogroups.com, Donald H Locker <dhlocker@...> wrote:
>
> Need the heat. If the laminator doesn't have the power, or if its temperature control is set too low, it will never get the board up to temperature. Heating the board with a flat iron will overcome this deficiency.
>
> Donald.
> ----- "sailingto" <sailingtoo@...> wrote:
>
> > Why not just run the bare copper board thru the laminator a few times
> > until it's not, then do the toner transfer with laminator?
> >
> > Only one piece of equip that way.
> >