To Ken
I might have some in the shop. I will try to get a picture off to you today.
They are marked. :International Eyelets, Inc" F-4093-c, F-6093-c
Bob
On 1/27/2010 8:59 PM, sailingto wrote:
> Is there any place to get just a few eyelets to test out? Heck, even at 10 or 20 samples would keep me going for a while - I only make 2 to 4 boards/month - and each of those usually have 3 or 4 vias.
>
> Thanks for any guidance to a source.
>
> Ken H.
>
> --- In Homebrew_PCBs@yahoogroups.com, Leon Heller<leon355@...> wrote:
>
>> On 27/01/2010 02:55, Terry Mickelson wrote:
>>
>>> On 26-Jan-10, at 1:10 PM, Paul Mateer wrote:
>>>
>>> Keystone has them: http://www.keyelco.com/products/specs/eyeletspec.asp
>>>
>>> -Reply:
>>>
>>>
>>>
>>> Sorry, no good. A wide flange eyelet is useless for dip packages
>>> because their flanges would overlap each other. Are there any other
>>> sources that don't insist on UPS and their extra charges?
>>>
>>
>> Try Multicore Copperset:
>>
>> http://www.prime-electronics.com.au/datasheets/data/Multicore/Wave%20Soldering/Acessories/Through%20Hole%20Repair%20Kit/Tech%20Data%20Sheet.pdf
>>
>> The kits are expensive, though.
>>
>> Leon
>>
>>
>
>
>
> ------------------------------------
>
> Be sure to visit the group home and check for new Links, Files, and Photos:
> http://groups.yahoo.com/group/Homebrew_PCBsYahoo! Groups Links
>
>
>
>
>