That, combined with your tools and skill.
What's the recommended trace width: LARGE
What's the recommended spacing: LARGE
What's the recommended pad size: LARGE
In short, put as much copper down as you can. Trace width/spacing is
usually best near a 1:1 ratio for signal traces (e.g. 10mil trace
10mil distance).
Start with _at least_ 10 mil traces and 1mm restring around the holes,
more if you have the space.
ST
On Mon, Dec 21, 2009 at 3:06 PM, blalor76 <blalor@...> wrote:
> Ok, so taking the etching method out of the equation, I still need to drill out the holes without ripping them up. Is that just a function of the size of the annular ring?
>
>