I already own one. I tried using it before, but didn't like the
results. I even modified a couple of pens as I thought this might be
an easy way to "draw" boards to etch. I have owned this plotter
since new a long time ago.....
The main problems I had with trying the plotter were:
1. The ink would not last through the etch. At the time I think I
had tried to use a OHT marker (cut it off and used one of the plotter
pen bodies).
2. When the pen would "land" on the copper, tiny ink droplets would
splatter and make a mess of the fine traces.
3. The speed seemed WAY too fast to get nice dark lines that you
could get by hand with the same pen.
4. Securing the board to backing paper. As the plotter requires
paper to "grip". (The paper movement also seemed WAY too fast and
would sometimes move the board out of registration.)
5. The process seemed slow, and since I never got a decent board to
etch with this method, I abandoned it.
The plotter now once again collects dust in the closet :(
If you have any ideas to try, or like you said, software to try I
would be game to try it once again as I would like to get some more
use out of this practically new plotter.
--- In Homebrew_PCBs@y..., "caveteursus" <j.walton@a...> wrote:
> like the HP7475a which I own, I've written some code to also use it
> as an XY pen-plotter.