You can use comet but then use denatured or 91pct isopropyl alcohol to clean the soap residue off the board.
Then use a clean 3M pad to rough up the board.clean again with alcoholuntill no reside on the paper towel..
________________________________
From: Piers Goodhew <
piers@...>
To:
Homebrew_PCBs@yahoogroups.comSent: Sun, October 4, 2009 12:11:05 PM
Subject: Re: [Homebrew_PCBs] Double Sided boards - Was Laser Printer
On 04/10/2009, at 4:10 PM, Clint Corbin wrote:
> 1) I clean my boards with Comet (the blue-green kitchen/bath cleaning
The last board I did, I only gave the copper a good scratch with some
old sandpaper. Seemed to work quite well: I'm a long way from being
certain, but I am working up to the belief that the toner needs a
rough surface to get a grip on more than it needs a whole lot of
solvents thrown at the copper. If I ever get certain, I'll sing out
but I thought I'd share.
PG
[Non-text portions of this message have been removed]