Ok
I use the slowest speed. a full sheet takes about a minute
I used 10 -11 passes thru the laminator
the laminator is not modified
the board is single sided g-10 .062 thick 4.5x 6.5 inches .these boards dissipate a lot of heat so more passes with the
board being re-fed through is necessary to keep the board temp up. I have some .032 boards but I have not put them through it yet.
My LCD says 328 degrees .I have not measured the temp as I do not have a temp probe.
regards
mike
________________________________
From: Mike Phillips <mikep_95133@...>
To: Homebrew_PCBs@yahoogroups.com
Sent: Tuesday, August 11, 2009 11:50:33 AM
Subject: [Homebrew_PCBs] Re: Picture of board done with HP presentation paper
I meant 40 inches per minute....
Mike
--- In Homebrew_PCBs@ yahoogroups. com, "Mike Phillips" <mikep_95133@ ...> wrote:
>
> Hi Mike,
>
> That 535 laminator has 4 rollers and can go up to 40 feet/min. I have some questions about your process.
>
> 1) How long does it take to pass a letter size sheet of paper through lengthwise? My 310 takes 51 seconds.
>
> 2) How many passes did the board require through the laminator?
>
> 3) Any mods to the laminator?
>
> 4) Is the board double sided copper?
>
> 5) What temp did your laminator show on the LCD at the time of laminating?
>
> 6) Ever measured the roller temperatures?
>
> Thanks!
>
> Mike
>
>
>
> --- In Homebrew_PCBs@ yahoogroups. com, michael tenore <wb2lcw@> wrote:
> >
> >
> > Hi!
> >
> > I scanned one of my recent boards to the Photo section!
> > This was done with HP Presentation paper and applied to the Board with a GBC H535 Laminator
> > Board is 4.5 x 6.5 inches .062 thick..
> >
> > http://groups. yahoo.com/ group/Homebrew_ PCBs/photos/ album/1613902738 /pic/1067172535/ view?picmode= &mode=tn& order=ordinal& start=1&count= 20&dir=asc
> >
> > The board has been etched and drilled but the toner was not stripped off yet..
> >
> > I will post again when I strip the toner! You can see how nice it came out.
> >
> > regards
> >
> > mike..
> >
>
[Non-text portions of this message have been removed]