Ok Mike ,Here it is!
Paper name = "HP Presentation Paper 130g"
Glossy 34lb Brightness 97
On the back of the package there is a small Bar code It says Product Q2546A
Virtually all Staples store have it! By the way Staples stores in my area have Paper in two or three different areas of the store.. Look in the area
where they have blank certificate sheets but if you dont see it ask a store clerk UPC is 8 82780 35464 7
regards
mike
________________________________
From: Michel Baguet <
bagmik@...>
To:
Homebrew_PCBs@yahoogroups.comSent: Saturday, August 8, 2009 4:47:40 AM
Subject: Re: [Homebrew_PCBs] First toner transfer attempts.
Can you give more infos about the paper ? Full name, inkjet or laser, weigth, ...
Do you have to soak it ?
Mike
--- On Fri, 8/7/09, michael tenore <wb2lcw@yahoo. com> wrote:
From: michael tenore <wb2lcw@yahoo. com>
Subject: Re: [Homebrew_PCBs] First toner transfer attempts.
To: Homebrew_PCBs@ yahoogroups. com
Date: Friday, August 7, 2009, 6:35 PM
No I do not ! I am very satisfied with this paper.. You still have to inspect the board
any way but on a large board I only have to touch up a couple of spots. But that is due
to me getting a little aggressive when I have paper to remove between traces when traces are very close together.
I did two 6.5 x 4.5 ich boards with many traces and pads that came out virtually perfect..
I use a GBC H535 laminator that I recently got at a bargain on eBay for less than $100 with shipping
and I get very good results on large boards 1/16 thick with no modifications. .
my printer is a used HP 2100 that I found on line from a office near my job for $25.. This
paper works great with a iorn on small boards.. I also found heating boards with a iron and using a
wall paper seamer roller from home depot to apply preasure works quite well also, if you have to use an iron.
my iron is a el-cheapo dry iron I found in a variety store for $10!(It has no hole in the sole plate!)
This paper is only $13 for 300 sheets.
mike
[Non-text portions of this message have been removed]
[Non-text portions of this message have been removed]