I think I could do those for you (for free of course)
Is it single or double face? Can you at least drill the holes by
yourself? Or is it SMD? Can you provide a PDF document of the artwork?
You should print it out yourself with the "paging scaling 'none'" and
make sure it has the correct size.
bye
as
Jack Coats wrote:
> Sorry for the lack of information. I am near Nashville Tennessee 37015.
> Small boards, I don't have it in front of me, but about 2.5" wide and 3.8"
> long
> has two boards laid out on it.
>
> I have the layout in ExpressPCB's pcb file format, set up for their
> 'mini-board' service.
> It would cost me about $60 to get 3 boards delivered from them. But there
> are two
> boards on each of these so it would give m 6 project boards, and I need 2.
>
> thanks ... Jack at coats dot org is my home email
>
>
> On Wed, May 13, 2009 at 12:21 PM, Alessio Sangalli <alesan@...>wrote:
>
>> Jack Coats wrote:
>>
>>> If someone would like to give making one a shot, I'd be glad to forward
>> the
>>> link to the artwork.
>> Which country do you live in, ... state, size of the boards,
>> single/double, etc ?? Give us a little more information so that we can
>> help you
>>
>> bye
>> as
>>
>>
>>
>>
>> ------------------------------------
>>
>> Be sure to visit the group home and check for new Links, Files, and Photos:
>> http://groups.yahoo.com/group/Homebrew_PCBsYahoo! Groups Links
>>
>>
>>
>>
>
>
> [Non-text portions of this message have been removed]
>
>
>
> ------------------------------------
>
> Be sure to visit the group home and check for new Links, Files, and Photos:
> http://groups.yahoo.com/group/Homebrew_PCBsYahoo! Groups Links
>
>
>
>
>