Hi! What laminator did you buy and are you using 1/32" or 1/16" thick boards?
I am looking to buy a laminator but I am hoping some one could make valid recomendations based onthier expierience with
that model..
regards
Mike
________________________________
From: Alessio Sangalli <
alesan@...>
To:
Homebrew_PCBs@yahoogroups.comSent: Thursday, April 16, 2009 7:50:29 AM
Subject: [Homebrew_PCBs] First experiment
Hi I made my first PCB since I moved to USA.
The HP paper is good, the laminator I have bought is very, very good! I
am so satisfied.
Then I tried to etch with H2O2 + muriatic acid. I have a tank that
"bubbles" air. I have not used the heater.
Time: 4.00 minutes the board is ready. It is true this first board has
only thick traces, but the result is very good.
The only problem is that, after rinsing the board, I use some acetone to
remove the toner. It goes instantly but doing so it makes the PCB
"dirty", darker as it should be.
Any hint?
I have prepared a checklist with the tools and the step for the process.
I think I will take pictures next time and put together a small website.
bye
Alessio
[Non-text portions of this message have been removed]