--- In
Homebrew_PCBs@yahoogroups.com, "pork_u_pine2000" <wittend@...>
wrote:
>
> --- In Homebrew_PCBs@yahoogroups.com, "Carl W. Livingston"
> <microcarl@> wrote:
> >
> > I don't use any chemicals to clean my PCB panels. I use Scotch-
Brite
> > pads and dish soap & hot water to clean my PCB panels before
putting
> > the toner pattern on them.
> >
> ...
>
> >
> > I hope it helps...
> >
>
> Point taken, but since when isn't 'dish soap' a mystery mix of
> chemicals? Usually the stuff from the grocery is some undisclosed
> mixture of synthetic detergents, semi-synthetic detergents,
coloring,
> perfume, and thickening agents. No soap (soaponified fats) at all.
> Sometimes the stuff from the 'health food' stores is even scarier.
>
> -- dave
>
OK, poor choice of wording...
I don use anything other then dish soap and Scotch-Brite pads to
clean the Copper on my PCB blanks.
Is that a bit more generic???