Archive of the former Yahoo!Groups mailing list: Homebrew PCBs

Dave <theschemer@...> writes:

> Sounds good to me. I am using single sided boards so using the TT method
> will it transfer to the fiberglass or non-copper layer ok? Or is that

It should. In my photos it didn't, but that wasn't fiberglass - it
was an old THICK phonelic board, and the laminator just didn't get hot
enough to adhere it properly (it started to adhere in some places).
There might not have been enough pressure getting through to those
narrow places, as that may have been a 2oz board also.