If my only goal was to make a pretty board, I would have started over again.
Since my goal was to make a PC board, learn a little, and use the
circuitry I didn't feel the extra night expended was worth it. I only
posted so others might gain from my experiences:
1. the household iron doesn't work well at all (I had already spent a couple
of nights trying)
2. I didn't have to modify a brand new laminator
3. I didn't use an expensive or complicated etching setup
Have a nice day.
>
>why didn't you use the 'oops' process of removing the
>cuasi-failed process and start over?
>magazine paper shouldn't be too expensive to discard....
>why did you insist in rubbing and etching something you
>knew beforehand was less than good?
>
It's still
> > perfectly usable,
> > just not as pretty as it could be.
>
>
>
>
>____________________________________________________________________________________
>Get the Yahoo! toolbar and be alerted to new email wherever you're surfing.
>http://new.toolbar.yahoo.com/toolbar/features/mail/index.php
_________________________________________________________________
http://newlivehotmail.com