I'm a newbie here, found the forum while searching for info on pcb's.
I'm doing a short run of 12x18 boards, and am setting up a
screenprint for the resist. I've tried the toner transfer and had
little success. I need to have it so I can duplicate them a bunch of
times in the future too.
I was looking for a good tank for the etch, and intended to do spray
etch, hopefully with peroxy-sulfuric and acetic acid.
If you can find the larger tanks, I would be interested.
Kevin
>
> I also have a few which are much heavier...3/8 wall maybe;
> and with thick flanged tops. They are used, but reasonably
> clean....and larger/heavier. I think they might be 14x18x4"
> or 14x20x6"...something like that....haven't seen them in a few
> years.