--- In
Homebrew_PCBs@yahoogroups.com, "lcdpublishing"
<lcdpublishing@...> wrote:
>
> Well, I can't say as I am thrilled or dissappointed. I tried running
> a small PCB with fairly large traces. There are a number of problems
> that I will need to resolve before expecting a good PCB from the
> machine.
>
I forgot to mention to run the board at a short penetration, then
before you remove it, inspect it for any non-cuts. if the board is not
flat, there may be some rises, and some dips. you can re-cut the dips
pretty easily. Just erease everything else in your software and leave
the lines you want to re-cut.
A vac hold down will almost eleminate the board from flexing.
Dave