--- donahn <
donahn@...> wrote:
> Hi,
>
> I was wondering if anyone makes copper covered perfboard for etching.
> Basically, just a copper covered board that's been pre-drilled.
wouldn't it be easier to just CNC some rows of holes?
> ... For SMD, just send all your vias to a pre-existing hole.
I guess you are thinking of putting wires through? like those proto boards out
there that are not through plated.
Again I think some rows of CNC drilled holes would be easier on you...
More or less this is what I was thinking of when I asked about the WOODEN
ROUTER.
____________________________________________________________________________________
Do you Yahoo!?
Everyone is raving about the all-new Yahoo! Mail beta.
http://new.mail.yahoo.com