Archive of the former Yahoo!Groups mailing list: Homebrew PCBs

Stefan, the C84 conversion webpage says, "If you use very thin (60mil/1.5mm),
then skip these steps.
Am I missing something. To me, 60mil or 1/16" is quite thick. It used to be
the most common available but I see 1/32 and 1/64 is now fairly common, too.
Are you saying that the C84 will pass the smaller gauges without modification?
How thick can the C84 take before the head needs to be raised?
TIA,

(also, I'm curious as to why you chose the C84 if there is any other reason
other that it was "there")


Tuck